Bucket hinge pin: 120.0 in (3.05 m) | Top of ROPS: 77.7 in (1.97 m) | Bottom of level bucket, fully raised: 113.2 in (2.88 m) | Dump: with foundry/excavating bucket - 93.7 in (2.38 m) @ 45°, with low profile bucket - 90.7 in (2.31 m) @ 45°
Specifications
2017
Case CE
SV185
Base
General
ISM N844LTA-DI-F-45
Tier 4 Final
@ 2800 RPM – SAE J1349: Gross - 60 hp (44.7 kW), Net - 57 hp (42.4 kW)
Peak @ 1400 RPM: 135 lb·ft (183 N·m)
High idle – no load: 2825 +/- 25 | Rated – full load: 2800 Rpm | Low idle: 1200 +/- 50 rpm
#: 4
135.2 in3 (2.2 L)
3.31 in (84 mm)
3.94 in (100 mm)
Type: Direct drive countershaft Powershift w/ electronic shift control and inching pedal
Maximum dump angle: 51.9° | Angle of departure: 23.0° | Clearance circle rear: 71.2 in (1.81 m)
Operating: with foundry/excavating bucket - 150.4 in (3.82 m), with low profile bucket - 154.6 in (3.93 m), with low profile extended bucket - 159.6 in (4.06 m)
Bucket hinge pin: 120.0 in (3.05 m) | Top of ROPS: 77.7 in (1.97 m) | Bottom of level bucket, fully raised: 113.2 in (2.88 m) | Dump: with foundry/excavating bucket - 93.7 in (2.38 m) @ 45°, with low profile bucket - 90.7 in (2.31 m) @ 45°
without attachment with coupler: 118.7 in (3.01 m) | F. with foundry/excavating bucket on ground: 143.5 in (3.64 m) | with low profile bucket: 141.5 in (3.75 m) | with low profile extended bucket: 152.7 in (3.89 m)
12-volt low-maintenance 1,000 cold-cranking amps @ 0° F (-18° C°)
Spring-applied, hydraulic release multiple disc.
19.5 gal (73.8 L)
Engine w/ filter: 7.5 qt (7.1 L)
Hydraulic system: Total - 8.5 gal (32.2 L), Reservoir - 4.3 gal (16.3 L)
Unit equipped w/ open cab; 165 lb operator; 72 in Low Profile bucket; full of fuel; 12 x 16.5 tires: 6,570 lb (2 980 kg) | Shipping: 6,270 lb (2 840 kg)